Disassembly Of Parts For Cleaning And Sterilization; Û Disassembly Of Parts For Cleaning And Sterilization - Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance

MULTIPIEZO PRO
As soon as the peristaltic pump starts, the
entire scale of values of the "irrigation"
section lights up and during the liquid
passage, the value of the irrigation shifts
from 6 a 0 . The cycle lasts 20 seconds. Once
it has ended, the keyboard is enabled again,
and displays the last setting used;
EN
To perform a cleaning cycle of both
handpieces repeat the operations described
above, from point 1 onward.
After the cleaning cycle of the irrigation circuit
move on to disassembing the different parts
07 Û DISASSEMBLY OF PARTS FOR CLEANING
AND STERILIZATION
Before moving on to the cleaning procedures described in Chapter 08 - CLEANING AND
STERILIZATION, disconnect all the accessories and components of the multipiezo pro.
DANGER: Switch the device off.
Always turn the device off via the switch,
and disconnect the power supply cable
from the power outlet and from the
device body, before performing the
cleaning and sterilization interventions.
If present, unscrew the insert from the
handpiece by using the torque wrench;
22
5
(see Chapter 07 - DISASSEMBLY OF PARTS FOR
CLEANING AND STERILIZATION) and to their
cleaning and sterilization (see Chapter 08 -
CLEANING AND STERILIZATION).
1
2
20"