Instructions For Use - Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance

MULTIPIEZO PRO
05.4 Û INSTRUCTIONS FOR USE
After having connected all the accessories as illustrated in Paragraph 04.3 proceed as follows:
To fill the irrigation circuit of the handpiece
chosen for the treatment lift the same
EN
handpiece from its support, select "auto"
under the CLEAN menu on the touch
keyboard: all the other selection options
present on the display are disabled, and the
screen flashes;
To start the CLEAN function while the
screen flashes press the foot pedal once and
release it; the screen stops flashing and the
irrigation circuit begins to be filled up;
As soon as the peristaltic pump starts, the
entire scale of values of the "irrigation"
section lights up and during the liquid
passage, the value of the irrigation shifts
from 6 to 0;
The cycle can be interrupted as soon you see
liquid outflowing from the multipiezo pro
handpiece, by pressing on "stop" under the
CLEAN menu or, alternatively, by pressing
the foot pedal. The function is disabled and
the keyboard is enabled again, and displays
the last setting used;
18
1
power light
6 auto
5 5 on
4 4
off
3
2
1
0
2
function
endo
perio/scaler
restorative
soft mode
3
4
power light
6
auto
5 5 on
4 4
off
3
2
1
0
multipiezo pro
handpiece
function clean irrigation
endo 6
auto
perio/scaler stop 5 5
4 4
restorative
3
soft mode 2
1
0
multipiezo pro
handpiece
function clean irrigation
6
endo auto
perio/scaler stop 5 5
4 4
restorative
3
2
soft mode
1
0