Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance page 17

handpiece
clean
power light function
6
auto endo
auto
5 5 on perio/scaler stop
4 4
off restorative
3
2
soft mode
1
0
SOFT MODE
Once the PERIO/SCALER or the RESTORATIVE
function is selected, you can make the
treatment more delicate by choosing the "soft
mode".
The function is not available in ENDO. In
case you select RESTORATIVE the "soft mode"
cannot be used together with the power set
on 6.
Indicated for very sensitive patients.
FILLING AND CLEANING THE IRRIGATION
CIRCUIT
multipiezo pro
The device is equipped with the "clean" key
which allows to flush the entire irrigation
irrigation
line up to the insert, so that the treatment
6
can be started with the necessary irrigation
5 5
(see Paragraph 05.4), or to perform a cleaning
4 4
cycle of the irrigation circuit (see Chapter 06 -
3
CLEAN FUNCTION).
2
1
The function CLEAN must be performed
0
when you have finished using the device and
before cleaning, disinfecting, and sterilizing
all the parts (see Chapter 08 - CLEANING AND
STERILIZATION).
IRRIGATION
The capacity of the peristaltic pump can be
adjusted by selecting the numbers on the
touch keyboard in the "irrigation" column.
7 capacity levels are foreseen:
0 = operation of the pump is closed: no
irrigation outflows from the insert.
From 1 to 6= the pump flow goes from
10 ml/min to approximately 40 ml/min.
The possibility of choosing the irrigation
capacity levels is tied to the type of function
selected, in the following manner:
ENDO - 6 flow levels: from 1 to 6
It is always possible to set irrigation on 0.
PERIO/SCALER - 6 flow levels: from 1 to 6.
It is always possible to set irrigation on 0.
RESTORATIVE - 6 flow levels: from 1 to 6.
It is possible to set irrigation on 0 only with
the power set from 1 to 5.
Selecting RESTORATIVE and power on 6 the
irrigation is compulsory.
05 Û USE
R
(ref. inside cover)
S
(ref. inside cover)
T
(ref. inside cover)
EN
15