Annexe 1 : Warning And Error Messages - Metrix GX1010 Notice De Fonctionnement

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Warning messages are given when a setting may not give the expected result, e.g. DC
Offset attenuated by the output attenuator when a small amplitude is set; the setting is,
however, implemented.
Error messages are given when an illegal setting is attempted; the previous setting is
retained.
The last two warning/error messages can be reviewed by pressing EDIT followed by MSG
(the shifted function of 0), the latest is reported first.
Warning and error messages are reported with a number on the display; only the number is
reported via the remote control interfaces.
The following is a complete list of messages as they appear on the screen. In most cases
they are self-explanatory but where doubt may arise some further explanation is given.
• Warning Messages
00
07
09
10
11
14
17
20
22
23
24
25
• Error Messages
101
102
103
104
105
106
108
112
113
115
116
118
119
66 - II

ANNEXE 1 : Warning and Error Messages

No errors or Warns have been reported.
DC Offset change by Output level
Symmetry too wide for func/freq
Symmetry changed by function/freq
DC Offset atten by Output level
Trigger Generator max res 20us
Phase angle change by function/freq
This instrument is not calibrated
Operation is illegal here.
This warning is used when certain key entries are attempted during
operations where they are not permitted. Such operations include:
The instrument is a synchronous slave
Edit modes of STAIR and ARB
HOP mode selected
Noise selected
Full explanations of the restrictions will be found in the appropriate
operational sections of the manual.
Mode illegal when synchronous slave
Burst time exceeds TGEN period
DC Offset + level may cause clipping
Frequency/Period Val out of range
Max Output level exceeded
Min Output level exceeded
Requested units are illegal here
Min DC Offset exceeded
Max DC Offset exceeded
Symmetry value is illegal
Trigger generator period too big
Trigger generator period too small
Burst count value out of range
Phase angle value out of range
Trigger generator fixed by am sine
Mod depth value out of range
GX1010

Publicité

Chapitres

Table des Matières
loading

Table des Matières