Trigger And Gate; Am Parameters; Fsk Parameters - Metrix GX1010 Notice De Fonctionnement

SWPBEGPER <nrf>
SWPENDFRQ <nrf>
SWPENDPER <nrf>
SWPMKRFRQ <nrf>
SWPMKRPER <nrf>
SWPMODE <cpd>
SWPLAW <cpd>
SWPTIME <nrf>
SWPSRC <cpd>
∗TRG

5.2.4. Trigger and Gate

TRIG <cpd>
GATE <cpd>
TRIGSRC <cpd>
GATESRC <cpd>
TGEN <nrf>
BCNT <nrf>
PHASE <nrf>
∗TRG

5.2.5. AM Parameters

AM <cpd>
AMSRC <cpd>
TGEN <nrf>
AMDEPTH <nrf>
AMWAVE <cpd>

5.2.6. FSK Parameters

FSK <cpd>
FSKFRQA <nrf>
FSKPERA <nrf>
FSKFRQB <nrf>
FSKPERB <nrf>
FSKSRC <cpd>
TGEN <nrf>
∗TRG
GX1010
Set sweep begin period to <nrf> seconds
Set sweep end frequency to <nrf> Hz
Set sweep end period to <nrf> seconds
Set sweep marker frequency to <nrf> Hz
Set sweep marker period to <nrf> seconds
Set sweep mode to <BTOE> (begin to end) or <ETOB> (end
to begin)
Set sweep law to <LOG> or <LIN>
Set sweep time to <nrf> seconds
Set sweep source to <CONT> (continuous), <EXT> (external)
or <MAN> (manual)
Executes a trigger which will have the same effect as pressing
the MAN/SYNC key. MAN/REMOTE trigger source must be
selected first. GPIB Group Execute Trigger command (GET)
will perform the same function as ∗ ∗ ∗ ∗ TRG.
Set trigger mode to <ON> or <OFF>
Set gate mode to <ON> or <OFF>
Set trigger source to <EXT>, <MAN> or <TGEN>
Set gate source to <EXT>, <MAN> or <TGEN>
Set trigger generator period to <nrf> seconds
Set burst count to <nrf> cycles
Set phase to <nrf> degrees
Executes a trigger which will have the same effect as pressing
the MAN/SYNC key. MAN/REMOTE trigger source must be
selected first. GPIB Group Execute Trigger command (GET)
will perform the same function as ∗ ∗ ∗ ∗ TRG.
Set AM mode to <ON> or <OFF>
AM source to <EXT> or <TGEN>
Set trigger generator period to <nrf> seconds
Set internal AM depth to <nrf> %
Set internal AM wave to <SINE> or <SQUARE>
Set FSK mode to <ON> or <OFF>
Set main generator
completeness only)
Set main generator
completeness only)
Set FSK frequency B to <nrf> Hz
Set FSK period B to <nrf> seconds
Set FSK source to <EXT>, <MAN> or <TGEN>
Set trigger generator period to <nrf> seconds
Executes a trigger which will have the same effect as
pressing the MAN/SYNC key. MAN/REMOTE trigger source
frequency to <nrf>
period to <nrf>
Hz (for
seconds (for
II - 47