Staircase And Arbitrary Waveforms; Waveform Generation Options; Hop; System Commands - Metrix GX1010 Notice De Fonctionnement

5.2.7. Staircase and Arbitrary Waveforms

STAIR
SETSTAIR <nrf>,...<nrf>
ARB
SETARB <nrf>,...<nrf>
ARBSAV <nrf>, <cpd>
ARBRCL<nrf>
ARB?

5.2.8. Waveform Generation Options

SQRWAVGEN <cpd>
FILTER <cpd>
AUX <cpd>
SWPTRGOUT <cpd>

5.2.9. HOP

HOP <cpd>,<nrf>
SETHOP <nrf>,<nrf>,
<nrf>,<nrf>,<cpd>,<nrf>
∗TRG

5.2.10. System Commands

BEEPMODE <cpd>
BEEP
48 - II
must be selected first. GPIB Group Execute Trigger
command (GET) will perform the same function as ∗ ∗ ∗ ∗ TRG.
Set staircase function
Define a new staircase function. Up to 16 pairs of length
and level may be specified; valid length range 0000 to 1024,
valid level -512 to +511.
Set arbitrary function
Define a new Arbitrary function. 1024 values must be
specified to set the waveform, each one a level in the range
-512 to +511.
Save arbitrary waveform to store <nrf> with name
<character data>. The maximum length of the name is 16
characters.
N.B. If it is required to retain a waveform sent by a SETARB
command, ARBSAV must be used immediately after
SETARB. If this is not done, any other 'ARB' operation
except ARB will will destroy the data. The waveform data
will also be lost at power down unless it is saved first.
Recall arbitrary waveform from store <nrf>
Query the selected arbitrary waveform; responds SETARB
<1024 nr1><rmt>
Set squarewave generation mode to <AUTO>,<HF>or<LF>
Set filter mode to <AUTO>,<ON> or <OFF>
Set AUX output mode to <AUTO>,<HF> or <LF>
Set sweep/tgen
<AUTO>,<SWEEP>or<TGEN>
Set HOP status to <RUN> or <OFF> with last step set to
<nrf>.
Data for one step in the sequence :
<step>,<time>,<freq>,<level>, <func>,<offset>.
<step> is the step number to be defined.
<time> is the time in seconds to remain in this step. If set to
0 MANUAL will be selected. If set to le-3 EXTERNAL will be
selected.
<freq> is the main generator frequency in Hz.
<level> is the output level expressed in EMF Vpp.
<func>isany of
<SINE>,<SQUARE>,<TRIAN>,<POSPUL>,<NEGPUL>,
<POSRAMP>,<NEGRAMP>,<STAIR> or <ARB>.
<offset> is the DC Offset in Volts.
Executes a trigger which will have the same effect as
pressing the MAN/SYNC key. MAN/REMOTE trigger source
must be selected first. GPIB Group Execute Trigger
command (GET) will perform the same function as
Set beep mode to <ON>,<OFF>,<WARN> or <ERROR>
Sound one beep.
output bnc mode to
∗ ∗ ∗ ∗ TRG.
GX1010