Status Commands - Metrix GX1010 Notice De Fonctionnement

∗RCL <nrf>
∗RST
∗SAV <nrf>

5.2.11. Status Commands

∗LRN?
LRN <character data>
EER?
QER?
∗CLS
∗ESE <nrf>
∗ESE?
∗ESR?
∗IST?
∗OPC
∗OPC?
∗PRE <nrf>
∗PRE?
∗SRE <nrf>
∗SRE?
GX1010
Recalls the instrument set up contained in store number
<nrf>. Valid store numbers are 0 - 9. Recalling store 0 sets all
parameters to the
INSTRUMENT SETTINGS)..
Resets the instrument parameters to their default values (see
DEFAULT INSTRUMENT SETTINGS).
Saves the complete instrument set up in the store number
<nrf>. Valid store numbers are 1 - 9.
Returns the complete set up of the instrument as a
hexadecimal character data block approximately 842 bytes
long. To re-install the set up the block should be returned to
the instrument exactly as it is received. The syntax of the
response is LRN <Character data><rmt>.The settings in the
instrument are not affected by execution of the ∗LRN?
command.
Install data for a previous ∗ ∗ ∗ ∗ LRN? command.
Query and clear execution error number register. The
response format is nr1<rmt>.
Query and clear query error number register. The response
format is nr1<rmt>
Clear status. Clears the Standard Event Status Register,
Query Error Register and Execution Error Register. This
indirectly clears the Status Byte Register.
Set the Standard Event Status Enable Register to the value
of <nrf>.
Returns the value in the Standard Event Status Enable
Register in <nr1> numeric format. The syntax of the
response is <nr1><rmt>
Returns the value in the Standard Event Status Register in
<nr1> numeric format. The register is then cleared. The
syntax of the response is <nr1><rmt>
Returns ist local message as defined by IEEE Std. 488.2.
The syntax of the response is 0<rmt>, if the local message
false or1<rmt>, if the local message is true.
Sets the Operation Complete bit (bit 0) in the Standard Event
Status Register. This will happen immediately the command
is executed because of the sequential nature of all
operations.
Query operation complete status. The syntax of the response
is 1<rmt>. The response will be available immediately the
command is executed because of the sequential nature of all
operations.
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register in
<nr1> numeric format. The syntax of the response is
<nr1><rmt>
Set the Service Request Enable Register to <nrf>. If the
value of <nrf>.
Returns the value of the Service Request Enable Register in
<nr1> numeric format. The syntax of the response
is<nr1><rmt>
default settings (see DEFAULT
II - 49