Gpib Interface - Metrix GX1010 Notice De Fonctionnement

Talk mode will also be cancelled when the instrument has completed sending a response
message or has nothing to say.
The interface code 0AH (LF) is the Universal Command and response Terminator (UCT); it
must be the last code sent in all commands and will be the last code sent in all responses.
The interface code 0DH (CR) may be used as required to aid the formatting of commands;
it will be ignored by all instruments. Most instruments will terminate responses with CR
followed by LF.
The interface code 13H (XOFF) may be sent at any time by a listener (instrument or
controller) to suspend the output of a talker. The listener must send 11H (XON) before the
talker will resume sending. This is the only form of handshake control supported by ARC.
5.1.2.4. ARC Interface Control Code List

5.1.3. GPIB Interface

When the GPIB interface is fitted the 24-way GPIB connector is located on the instrument
rear panel.
The pin connections are as specified in IEEE Std. 488.1-1987 and the instrument complies
with IEEE Std. 488.1-1987 and IEEE Std. 488.2-1987.
5.1.3.1. GPIB Subsets
This instrument contains the following IEEE 488.1 subsets:
Source Handshake
Acceptor Handshake
Talker
Listener
Service Request
Remote Local
Parallel Poll
Device Clear
Device Trigger
Controller
Electrical Interface
40 - II
02H SAM Set Addressable mode.
03H UNA Universal Unaddress control code.
04H LNA Lock Non-Addressable mode control code.
06H ACK Acknowledge that listen address received.
0AH UCT Universal
Terminator.
0DH CR Formatting code, otherwise ignored.
11H XON Restart transmission.
12H LAD Listen Address - must be followed by an
address
instrument.
13H XOFF Stop transmission.
14H TAD Talk Address - must be followed by an
address
instrument.
18H UDC Universal Device Clear.
Command
belonging to
belonging to
SH1
AH1
T6
L4
SR1
RL1
PP1
DC1
DT1
C0
E2
and response
the required
the required
GX1010