Metrix GX1010 Notice De Fonctionnement page 138

∗TRG
∗TST?
∗WAI
ABORT
AM <cpd>
AMDEPTH <nrf>
AMSRC <cpd>
AMWAVE <cpd>
ARB
ARB
ARB?
ARBRCL<nrf>
ARBSAV <nrf>, <cpd>
AUX <cpd>
BCNT <nrf>
BEEP
BEEPMODE <cpd>
CLOCKBNC <cpd>
DBM (nrf>
DCOFFS <nrf>
EER?
EMFPP <nrf>
EMFRMS <nrf>
FILTER <cpd>
FREQ <nrf>
FSK <cpd>
FSKFRQA <nrf>
FSKFRQB <nrf>
FSKPERA <nrf>
FSKPERB <nrf>
FSKSRC <cpd>
GATE <cpd>
GATESRC <cpd>
HOP <cpd>,<nrf>
LRN <character data>
NEGPUL
NEGRAMP
NOISE <cpd>
OUTPUT <cpd>
PDPP <nrf>
PDRMS <nrf>
PER <nrf>
PHASE <nrf>
GX1010
Executes a trigger which will have the same effect as
pressing the MAN/SYNC key.
The generator has no self-test capability and the response is
always 0<rmt>
Wait for operation complete true.
Abort on unsuccessful phase locking operation.
Set AM mode to <ON> or <OFF>
Set internal AM depth to <nrf> %
AM source to <EXT> or <TGEN>
Set internal AM wave to <SINE> or <SQUARE>
Set arbitrary function
Set arbitrary function
Query the selected arbitrary waveform.
Recall arbitrary waveform from store <nrf>
Save arbitrary waveform to store <nrf> with name <character
data>.
Set AUX output mode to <AUTO>,<HF> or <LF>
Set burst count to <nrf> cycles
Sound one beep.
Set beep mode to <ON>,<OFF>,<WARN> or <ERROR>
Set clock bnc mode to <OUTPUT>,<INPUT> or <SLAVE>
(phase lock)
Set output level to <nrf> pd dBm
Set dc offset to <nrf> Volts
Query and clear execution error number register.
Set output level to nrf emf Vpp
Set output level to <nrf> emf Vrms
Set filter mode to <AUTO>,<ON> or <OFF>
Set main frequency to <nrf> Hz
Set FSK mode to <ON> or <OFF>
Set main generator frequency to <nrf> Hz (for completeness
only)
Set FSK frequency B to <nrf> Hz
Set main generator
completeness only)
Set FSK period B to <nrf> seconds
Set FSK source to <EXT>, <MAN> or <TGEN>
Set gate mode to <ON> or <OFF>
Set gate source to <EXT>, <MAN> or <TGEN>
Set HOP status to <RUN> or <OFF> with last step set to
<nrf>.
Install data for a previous ∗ ∗ ∗ ∗ LRN? command.
Set negative pulse function
Set negative ramp function
Set NOISE <ON> or <OFF>
Set output <ON>, <OFF>, <NORMAL> or <INVERT>
Set output level to <nrf> pd Vpp
Set output level to <nrf> pd Vrms
Set main period to <nrf> seconds
Set phase to <nrfx> degrees
period to <nrf> seconds (for
II - 51