Metrix GX1010 Notice De Fonctionnement page 139

PHASE <nrf>
POSPUL
POSRAMP
SETARB <nrf>,...<nrf>
SETHOP
<nrf>,<nrf>,<cpd>,<nrf>
SETSTAIR
<nrf>,...<nrf>
SINE
SQRWAVGEN <cpd>
SQUARE
STAIR
STAIR
SWEEP <cpd>
SWPBEGFRQ <nrf>
SWPBEGPER <nrf>
SWPENDFRQ <nrf>
SWPENDPER <nrf>
SWPLAW <cpd>
SWPMKRFRQ <nrf>
SWPMKRPER <nrf>
SWPMODE <cpd>
SWPSRC <cpd>
SWPTIME <nrf>
SWPTRGOUT <cpd>
SYMM <nrf>
TGEN <nrf>
TGEN <nrf>
TGEN <nrf>
TRIAN
TRIG <cpd>
TRIGSRC <cpd>
ZOUT <nrf>
52 - II
Set phase to <nrf> degrees
Set positive pulse function
Set positive ramp function
Define a new Arbitrary function.
<nrf>,<nrf>, Data for one step in the sequence .
Define a new staircase function.
Set sine function
Set squarewave generation mode to <AUTO>,<HF>or<LF>
Set square function
Set staircase function
Set staircase function
Set sweep mode to <ON> or <OFF>
Set sweep begin frequency to <nrf> Hz
Set sweep begin period to <nrf> seconds
Set sweep end frequency to <nrf> Hz
Set sweep end period to <nrf> seconds
Set sweep law to <LOG> or <LIN>
Set sweep marker frequency to <nrf> Hz
Set sweep marker period to <nrf> seconds
Set sweep mode to <BTOE> (begin to end) or <ETOB> (end
to begin)
Set sweep source to <CONT> (continuous), <EXT>
(external) or <MAN> (manual)
Set sweep time to <nrf> seconds
Set
<AUTO>,<SWEEP>or<TGEN>
Set symmetry to <nrf> %
Set trigger generator period to <nrf> seconds
Set trigger generator period to <nrf> seconds
Set trigger generator period to <nrf> seconds
Set triangle function
Set trigger mode to <ON> or <OFF>
Set trigger source to <EXT>, <MAN> or <TGEN>
Set output impedance to <nrf>; only 50 or 600 are legal.
sweep/tgen output bnc mode
GX1010
to