Metrix GX1010 Notice De Fonctionnement page 149

Non-phase coherent signal keying - output carrier wave is on while Gate signal is high and
off while low.
Carrier frequency:
Carrier waveforms:
Trigger rep. rate:
Gate signal source:
• Sweep
Carrier Waveforms:
Sweep Mode:
Sweep Width:
Sweep Time:
Markers:
Sweep Trigger source:
• Amplitude Modulation
Carrier frequency:
Carrier waveforms:
Depth:
Internal source:
External:
• Frequency Shift Keying (FSK)
Phase coherent switching between two selected frequencies at a rate defined by the
switching signal source.
Carrier frequency:
Carrier waveforms:
Switch repetition rate:
Switching signal source:
• Start/Stop Phase
Carrier frequency:
Carrier waveforms:
Range:
Resolution:
Accuracy:
• Trigger Generator
Internal source 0·005 Hz to 50 kHz squarewave adjustable in 20µs steps. 3 digit resolution.
Available for external use from TRIG/SWEEP OUT socket.
7.2.1.5. OUTPUTS
• Main Output
Output Impedance:
62 - II
From 0·1 mHz to 10 MHz.
All
dc to 50 kHz internal, dc to 1 MHz external.
Internal from keyboard or trigger generator. External
from EXT TRIG input or remote interface.
All
Linear or logarithmic, single or continuous.
From 0·1 mHz to 10 MHz in one range. Phase
continuous. Independent setting of the start and stop
frequency.
10ms to 999s (3 digit resolution).
Two, variable during sweep. Available at the rear panel
TRIG/SWEEP OUT socket.
The sweep may be free run or triggered from any of the
following sources: Internal from keyboard. External from
EXT TRIG input or remote interface.
From 0·1mHz to 10 MHz.
All.
Variable 0 to 100% typical, resolution 1%.
1 kHz fixed sinewave or 0·005 Hz to 50 kHz squarewave.
See VCA In
From 0·1mHz to 10 MHz.
All.
dc to 50 kHz internal, dc to 1 MHz external.
Internal from keyboard or trigger generator. External
from EXT TRIG input or remote interface.
0·1 mHz to at least 1MHz.
All.
-360 to +360 degrees.
1 degree.
Typically 1 degree to 30 kHz.
50Ω or 600Ω
GX1010