Publicité
installation guide
Always use two people when setting up the base
STEP 1
Place the bed base box in a desired location with the
bottom of the box facing up.
Remove the binding straps and packing materials, making
sure not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the
bottom of the base facing upwards for easier access to
the beds components
STEP 3
To install the legs, thread the washer over the bolt of the
leg with the recessed side facing the leg, and tighten by
hand. Do not over tighten.
To install headboard brackets:
See detailed instructions on page 18 -19.
10
STEP 4
To sync two bases with the SmartSync™
(e9/e6+/e6/e4+): see detailed installation
instructions on page 24.
To sync two bases with the Y-Cord (e4):
see detailed installation instructions on page 25.
FOR e9/e6+/e6/e4+
Uncoil the Power Down Box
from the frame and install
(2) 9 Volt batteries - optional,
not included.
Place box on the ground.
Ensure that it is easily accessible
when the base is turned to its upright position. For
power down box operating instructions see page 20.
FOR e4
Locate the Backup
Battery Pack and install
(4) 9 Volt batteries
(not included).
Store the battery
pack in a convenient
location for
emergency use. For battery backup operating
instructions see page 21.
STEP 5
Uncoil input cord (connected to control box's power
port) and plug into Power Supply.
installation guide
Always use two people when setting up the base
STEP 6
Uncoil the Power Cord and connect to the Power Supply.
Place Power Supply on the ground and extend from
the base.
Ensure that the Power
Supply and all attached
cords are directed
toward the desired
surge protector.
STEP 7
Carefully flip the base over on to its legs.
Important: Two people are required to move the bed
base. Do not drag across the floor. Do not rest frame
on its side, excessive pressure may damage the legs.
STEP 8
Plug the base into a power source. A surge protector is
strongly recommended.
STEP 9
FOR e9/e6+/e6/e4+
Ensure that batteries are
correctly installed.
FOR e4
Ensure the wired remote is
plugged into the control box
Quickly test functions to verify proper setup before
placing mattress on base. Use remote to return the
base to a flat position.
STEP 10
Locate the mattress retainer bar brackets.
Slide the left side of the mattress retainer bar into the
bracket. Pull the retainer bar to the opposite bracket
and secure the right side.
Basic setup is now complete! See page 12-17 for remote
control operating instructions.
11
Publicité
