Publicité
e9/e6
/e6/e4
syncing two bases
+
+
For Series e9/e6+/e6/e4+ only. See page 25 for syncing two bases for the e4 series.
If simultaneous operation of two bases is desired, use the SmartSync™ Cord
to connect the electronics of both bases together.
STEP 1
Unplug base from power source.
STEP 2
Disconnect the power-down box cable from each
control box or splitter cable (e6+). Make note where the
cable was plugged in.
STEP 3
Connect the male end of each sync cord to control box
or splitter cable (e6+). Insert it into the same port that
you disconnected the power-down box from in Step 2.
Control Box
Splitter
Power down box
24
STEP 4
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
STEP 5
Plug base back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page 22).
Control Box
Sync Cord
Splitter
Power down box
e4 syncing two bases
For Series e4 only. See page 24 for syncing two bases for the e9/e6+/e6/e4+ series.
A Y-Cord is included with the base. Not available on Queen, Full or Full-Long size bases.
The Y-Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source.
STEP 2
Locate the control box underneath the base. P lug end
of y-cord into wired remote port on the control box.
Repeat for other end of cord and second control box.
STEP 3
Plug remote into Y-Cord
STEP 3
Once the remote has been connected to the control
box with the y-cord, plug bases into power outlet and
test all functions.
Control Box
Control Box
Bed A
Bed B
Remote
Y-Cord
25
Publicité
