Publicité
e9/e6
/e6/e4
pair remote
+
+
The original remote that comes in the box is already paired to the bed base. No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote
control. Remove and replace
batteries.
STEP 2
Double click the button on the
Power Down Box (this will not
cause the base to move). The
light will illuminate.
If the Power Down Box is not available :
Remove back cover of the remote, locate the rubber button in the center of the back. On the control box located
underneath the bed, double click the RESET button, light will illuminate. Press and hold the back rubber
button on the remote. The button will begin to flash then become a continuous solid light for 1 to 2 seconds
and then turn off. Once the remote is paired, replace back cover of the remote and test base functionality.
22
STEP 3
Press and hold button on the back
of the remote. The light will begin
to flash then become a continuous
solid light.
STEP 4
Both lights on the Power Down Box
and the Remote will be continuous,
then simultaneously turn off.
Replace back cover of the remote.
The remote is now paired with the
base.
setting up two bases
Connecting straps are secured to the base frame upon delivery.
If a split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases
together. Use both straps to secure the head and foot portions together.
STEP 1
With the bases in their desired location, slightly loosen both legs to allow the strap to fit on the leg bolt,
between the leg washer and frame.
STEP 2
Slide side (a) of the connecting strap onto leg bolt. Swing the strap and connect side (b) to the leg bolt. Secure
the strap by shifting to the left.
STEP 3
Re-tighten legs. Do not over tighten. Use the remaining strap and repeat on other end of the base.
a
b
23
Publicité
