Publicité
e9/e6
/e6/e4
power down box
+
+
For Series e9/e6+/e6/e4+ only. See page 21 for e4 Battery Backup instructions.
Store the power down box in a convenient location for emergency use.
(2) 9 Volt batteries are required to operate the power down feature and are NOT included.
It is recommended to insert batteries into the power down box only when its use is required, and that batteries be
removed when the power down box is no longer in use. Leaving batteries in the power down box when not in use
may cause damage.
FOR EMERGENCY USE ONLY.
In the event that the base is stuck in an articulated position during a power outage-
the Power Down Box will return the base to a flat position.
The Power Down Box can only be used to bring the base to a flat position.
It will not bring the base to a flat position when the base is connected to a working power source.
STEP 1
Locate the Power Down Box under the base.
STEP 2
Press and hold the button until the base is flat.
Note: The button can be pressed at any time during the loss of power to bring the base flat.
20
e4 emergency battery backup pack
For Series e4 only. See page 20 for e9/e6+/e6/e4+ Power Down Box instructions.
Store the battery pack in a convenient location for emergency use.
(4) 9 Volt batteries are required to operate the power down feature and are NOT included.
It is recommended to insert batteries into the power down box only when its use is required, and that batteries be
removed when the power down box is no longer in use. Leaving batteries in the power down box when not in use
may cause damage.
FOR EMERGENCY USE ONLY.
In the event that the base is stuck in an articulated position during a power outage- the Battery Backup Pack
will return the base to a flat position. Batteries are not to be used for normal operation of the base.
Remove the battery pack after the emergency is over, as the system
will continue to draw power from the batteries, even if not in use.
STEP 1
Install the 9 volt batteries into the provided
battery pack.
Do not mix brand name batteries.
STEP 2
Connect battery pack to input power cord attached to control box.
Battery
Backup Box
Input
Power Cord
If the base is in the upright position use the remote to return to a flat position.
Control Box
21
Publicité
