Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GeneraL infOrMatiOn:
When unfolding the paraglider insure that neither the canopy nor the lines become too
dirty as dirt particles in the fibres can damage the material and lines. If the lines get
tangled on the ground they may be over-stretched or break during take-off.
> Do not step on the lines and/or canopy.
> Make sure that no sand, stones or snow get inside the canopy as the extra weight
collected in the trailing edge may slow down or even stall the glider.
> Sharp edges damage the canopy.
> uncontrolled inflation attempts in strong winds may result in the glider impacting
into the ground at high speed. This can cause rips, damage on lines and/or fabric.
> Make sure not to land your canopy leading edge first as this may cause permanent-
Damage to this area of your paraglider.
> After landings in trees or on water you should check the length of the lines.
> After contact with salt water thoroughly rinse the equipment with fresh water!
2-year-cHeck
skywalk specifies a maintenance interval after 24 months or 200 flying hours
(whichever occurs first).
According to regulations, the 2-Year Check must be carried out by the manufacturer, or
an authorised check center. The check must be confirmed with a stamp from skywalk
or the skywalk authorised check center. Missing this deadline, or if the check is car-
ried out by an unauthorised center will lead to immediate loss of your skywalk CHILI3
homologation and all warranty and liability claims. We fully recommend that you do not
carry out the check yourself. Without proper instruments and specific knowledge, the
check will be insufficient. The airworthiness of your glider can therefore not be guaran-
teed.
cHanGeS tO tHe ParaGLider:
Your skywalk CHILI3 is manufactured within the regulated parameters of tolerance.
These parameters are very narrow and must not be altered under any circumstances.
This applies as well to the brake line length. only this way can the optimum balance be-
tween performance, handling and safety be assured!
56

Publicité

Table des Matières
loading

Table des Matières