Publicité
Les langues disponibles
Les langues disponibles
rd
3
stage: Baking - 1
Programmes of 1 to 6 are designed to carry out 2 successive bakings. However, if you only
want to bake once, you must stop the machine manually by pressing
nd
Baking - 2
Cycle
st
Cycle
• Place the baking tray inside the breadmaker, in place of the tank.
• Press the button
the bread.
• At the end of the 1
30 min. Several beeps are emitted and the operating indicator light blinks.
• Remove the baking tray. Always use oven gloves because the tray is very
hot.
• Remove the loaves from the plates and leave them to cool on a wire
cooling rack.
• Leave the lid open so that the machine can
cool down sufficiently before starting the 2
round of baking.
• Arrange the remaining loaves on the non-
stick plates and then on to the baking tray.
Place inside the machine.
• Press the button
baking cycle.
• At the end of the cycle, the programme stops automatically. Several
beeps are emitted and the operating indicator light blinks. Unplug the
breadmaker.
• Remove the baking tray. Always use oven gloves because the tray is
very hot.
• Remove the loaves from the non-stick plates and leave them to cool on
a wire cooling rack.
again to restart the programme and start baking
st
baking cycle, the machine goes into sleep mode for
to start the second
for a long time.
nd
Run the plates under
cold water (to
cool them down) and
dry them before
using them for the
nd
2
baking operation.
TIP
30
Publicité
