MINN KOTA RIPTIDE Mode D'emploi page 7

3. Open upper arm, rotate and lay over out of the way for lower arm assembly.
4. Align the lower arm and the lower bow guard ears and insert lower pin.
5. Re-install spring clip into lower pin for freshwater models or (E-clip for saltwater motors).
6. Route rope underneath lower pin and through eyelet in bowguard.
7. Rotate upper arm back over to bowguard.
8. Align the upper arm holes with upper bow guard ears and install upper pin.
NOTE: The two bushings in the upper arm may come out. Re-assemble them into the upper arm making sure the "keys" of
the inserts are aligned with the "key" punchouts in upper arm.
9. Re-install washer and locknut and tighten.
10. Route rope through pull grip handle and small washer.
Secure by tying a fi gure eight knot.
©2015 Johnson Outdoors Marine Electronics, Inc.
Rope Eyelet
Spring Clip
(freshwater models only)
Lower Pin
Bushing
Upper Pin with
Nut & Washer
Washer
Figure 8 Knot
MOUNT INSTALLATION
E-Ring Clip
(saltwater models only)
Pull Grip
minnkotamotors.com | 7