probst HVZ-ECO Instructions D'emploi page 73

Adjustments
Machine Side
Adjust the gripping depth (machine side) so, that the
steel-lamellas are gripping in the
(see fig. 8).
Example: with stone layer breadth of 800 mm
 170 mm
Swing crank upwards.
Adjust the gripping depth identical on both sides of the
device (left and right).
51400034
½
of the stone layer
Fig. 7
Fig. 9
V3
With extremely large stone layers it recommends to
adjust the gripping depth a little lower, so that the steel-
lamellas grip in the lowest range of the stone layer.
Otherwise it exist the danger that the stone layer breaks
out.
½
Swing crank again downwards and secure it in the same
position (as before).
21 / 41
Fig. 8
Fig. 10
GB