probst HVZ-ECO Instructions D'emploi page 70

Adjustments
6 Adjustments
6.1 General
For all operations you have to make sure, that the device will not close unintended. Danger of
injury!!!
Caution with all adjustments exists danger of injury the hands!
6.2 Adjustments of the feather-steel-lamellas
51400034
●
The feather-steel-lamellas should not stitch out sideways
over the contur of the laying cluster, because they could
hit the already laid blocks when laying a new cluster into
an edge.
●
Depending on the length of a pack, the lamellas which are
stitching over, should be replaced by the 1.5 lamella or the
half lamella.
●
When mounting the screws with the feather-steel-
lamellas, pay attention to the configuration of the spring
washers as shown on the drawing. Tighten the self-locking
nuts tight and then loosen them again by 1/2 turn.
●
In order to give the feather-steel-lamellas a higher
flexibility and therefore a good, secure and gentle grip to
the pavers.
V3
18 / 41
GB