Ordering Information; Directives And Standards Complied With - ProMinent DULCOTEST CTE Mode D'emploi

Ordering Information / Directives and standards complied with

15 Ordering Information

Standard scope
of supply • CTE sensor
• Bottle of electrolyte (50 ml)
• Nozzle for bottle
• Membrane cap, spare membrane cap
• Operating instructions
• Small screwdriver
Complete kit The sensors can be ordered as a complete kit only
• CTE 1-mA-10 ppm
• CTE 1-mA-5 ppm
• CTE 1-mA-2 ppm
• CTE 1-mA-0.5 ppm
• CTE 1-DMT-10 ppm
Spare parts and
accessories • Accessory kit CGE 2/CTE 1 (2/5/10 ppm)
• Accessory kit CTE 1 (0.5 ppm)
• 1 membrane cap kit
• 1 membrane cap kit
Assembly kit • For DLG III
• For DGM
Accessories • 2-wire signal lead, mA variant
• Signal lead for chlorine sensors,
• Signal lead for chlorine sensors,
• Signal lead for chlorine sensors,
• Photometer DT 1

16 Directives and standards complied with

Conformity
declaration The total chlorine sensors of the CTE series have been developed and tested
in compliance with the European standards and directives. They are produced
to the highest quality standards as assured by European standards and
directives.
A corresponding conformity declaration can be obtained from ProMinent.
®
ProMinent
(2 membrane caps + 50 ml electrolyte)
(2 membrane caps + 50 ml electrolyte)
(CTE 1-mA-2/5/10 ppm and CTE-DMT-10 ppm) Order number
(CTE 1-mA-0.5 ppm)
2
(2x 0.24 mm , Ø 4 mm)
type DMT (2 m)
type DMT (5 m)
type DMT (10 m)
Order number 740684
Order number 1003203
Order number 740685
Order number 740686
Order number 1007540
Order number 740048
Order number 741277
792862
Order number 741274
Order number 815079
Order number 791818
Order number 725122
Order number 1001300
Order number 1001301
Order number 1001302
Order number 1003473
45