Decommissioning; Disposal; Ordering Information - ProMinent DULCOTEST CDP 1 1-mA-2 ppm Mode D'emploi

11 Decommissioning

Decommissioning sensor: observe all safety guidelines as given in section
5 "Assembly".

12 Disposal

Elektrolyte
The electrolyte is non-toxic and can be disposed of with in-house waste.
Sensor

13 Ordering Information

• 1 bottle of electrolyte (100 ml)
• 1 membrane cap
• Accessory set
• Two-wire signal cable
• CDP 1-mA-2 ppm (complete set)
The sensors themselves can be ordered only as complete sets:
1 sensor
1 bottle of electrolyte
2 replacement membrane caps
1 operating instructions manual
ProMinent ®
Decommissioning / Disposal / Ordering Information
Disconnect sensor from power supply (see 6 "Installation").
Depressurise the in-line probe housing assembly.
Loosen the tensioning screw.
Slowly pull out the sensor from the in-line probe housing assembly.
Unscrew the membrane cap over a wash basin or similar and empty.
Rinse away the electrolyte gel with cold water (see 9 "Servicing").
Rinse the electrodes with clean water and allow to dry.
Screw on a fresh membrane cap loosely to protect the electrodes.
Fit the membrane cap cover to protect the membrane cap.
IMPORTANT
• Electronic waste is classified as special waste.
• Observe currently applicable local directives.
(2 membrane caps + 1 bottle of electrolyte)
2
(2 x 0.25 mm , Ø 4 mm)
Part no. 1002712
Part no. 1002710
Part no. 1002744
Part no. 725122.6
Part no. 1002149
29