Furnotel CU 305 Instructions Pour L'installation page 44

Convection+Humidif.Combi Direct 5x2/3 GN / 7-11-20 x 1/1 GN / 7-11-20 x 2/1 GN
2.6 CONNECTING TO THE GAS MAINS
(Fig.2.6A)GAS HEATED OVENS
Connect the oven to connection (A) using metal pipes, either
in galvanised steel or copper, situated where they can be
seen.
The appliance must be connected to an on-off mains valve
that is easy to operate.
Use a 3-piece metal joint for connection between the pipe and
oven to facilitate removal.
Guarantee the seal of the joint threads using materials
declared, by their manufacturers, as being specifically suitable
also for LPG.
The appliance must be supplied with a suitable type of gas
(see the "technical data" table).
It is set for use with the type of gas indicated on the "rating" Fig. 2.6A
plate.
2.7 CHECKING FOR GAS LEAKS
Once the oven has been installed check there is no gas leaking into the room. This can done by
brushing joints and fittings with soapy water.
Bubbles prove there is a gas leak.
Note: never use bare flames to check for gas leaks
44