GYS GYSPACK 400 Manuel D'utilisation page 12

Translation of the original instructions
GENERAL DESCRIPTION
This autonomous starter is intended for the starting of vehicles equipped with a 12 V battery. GYSPACK functions thanks
to a high performance battery. For an appropriate use of the machine and a longer lifetime of its internal battery, it is
essential to connect to the sector the GYSPACK after each use and keep it connected until the next use.
Warning: To avoid any damage or explosion, respect the polarity during the clamp connection.
PRODUCT INTERFACE
Connection for the charger-adapter. Use only the charger-adapter provided with the product.
1
Red light
2 - Test mode: obligation to reload - Warning: never use the Gyspackauto when the red indicator lights on.
- Charger mode: the battery is charging.
Yellow light (test mode only): It is strongly advised to reload before use
3
Green light
- Test mode: The battery is charged. Can be used for starting vehicles.
4
- Charger mode: charge is finished. Floating: you can keep the product connected to the main supply.
5 Test Button: press this button to check the battery level.
TESTING OF THE INTERNAL BATTERY
Test the battery before each use: press on the test button, the result is displayed as follow:
- Green indicator: The battery is charged. Can be used for starting vehicles
- Orange indicator: It is strongly advised to recharge the GYSPACK before use.
- Red indicator: obligation to recharge.
Warning: never use the Machine when the red indicator is on.
STARTING OF A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.
1. Turn ignition off before connecting the GYSPACK to the car's battery.
Do not touch the red clamp with the black clamp.
2. Connect the red clamp to the positive pillar (+) of the battery, then the black clamp to negative pillar (-).
The cables must not be pinched or in contact with hot or sharp surfaces.
3. Go to the driver's seat and turn the ignition key. If your engine does not start, wait 3 minutes until next attempt. ( 6 sec. max)
- If the cooling period between each attempt (3 min.) is not observed or if the duration of the attempt is
too long (> 6 sec.), the chances of a successful jumpstart are significantly reduced (risk of power loss).
- Risk of battery acid leaks or damage if the recommended periods are not observed.
- If the vehicle does not start, it may be a problem other than a faulty battery: alternator, glowplug...
USE OF CIGARETTE LIGHTER PLUGS
12
GYSPACK 400 / 600
2
1
This type of cigarette lighter connection lead is limited to 10A. Supplied with some
of our GYSPACK, they are SOLELY designed for memory backup. Any other use can
be dangerous.
Risk of fire! We strongly advise against using the cigarette
lighter lead to jump start or power a 12V appliance for instance.
3 4
5
EN