GYS GYSPACK 400 Manuel D'utilisation page 11

Translation of the original instructions
Maintenance:
• The power supply cable cannot be replaced. If the
cable is damaged,the device should not be used.
• Service should be performed by a qualified person
• Warning! Always disconnect from the mains before
performing maintenance on the device (charger &
booster).
• If the internal fuse is blown, it must be replaced
by the manufacturer, its after-sales service or an
equally qualified person.
• Under no circumstances should solvents or other
aggressive cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our
website.
• EAC conformity
Commission)
• Equipment in compliance with British requirements.
The British Declaration of Conformity is available
on our website (see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is
available on our website (see cover page).
Disposal:
• This product should be disposed of at an appro-
priate recycling facility. Do not dispose of in do-
mestic waste.
• The battery fitted in this device is recyclable. Please
proceed according to the applicable recycling re-
gulations.
• The battery must be removed from the device be-
fore the latter is discarded.
• The device must absolutely be disconnected from
the power supply network before removing the
battery.
GYSPACK 400 / 600
mark (Eurasian Economic
EN
11