Dibo JMB-E 200/15 EB Manuel D'utilisation page 91

1 T H R OT T L E L E V E R
The throttle control happens automatically via the ETC controller. At not
operating the spray gun, the motor will be regulated to idle speed by the ETC.
At operating the spray gun, the motor will be regulated to maximum speed set
by the ETC.
Remark: Use the throttle handle NEVER
to arrange the spray pressure.
• Starting and warming up: Put the operating switch to position '2'. Key contact
will return automatically back to position '1'. If the engine does not start, wait
a minute before you repeat. If the engine does not start after two attempts,
follow the cause according the diagnostic table of the engine. Make sure that
all warning lights are off before the engine works. Allow the engine to run
warm at low rpm without load. Start the engine, electrically or with the traction
cord. When starting manually via the traction cable -> put the key contact to
position '1'.
• Switching off the engine: Let the engine run at stationary revs for a while to
cool down. Put the key switch to position '0'.
Make sure that the machine is switched off (OFF) after the spraying
activities, if it remains in ON position the battery will drain!
2 F U E L VA LV E
The fuel engine can be switched off electrically via the fuel valve.
3 K E Y C O N TAC T - E L E C T R I C A L LY S TA R T E D
The key contact has 3 positions & is situated on the operating compartment:
• 0 = off
• 1 = working position (control unit will be powered on, warning indicator on)
• 2 = start the engine
The engine switch need to be turned to position '2'. One must hold these there
(no longer then 5 sec) to the engine starts. If the engine does not start, wait 10
seconds, before trying again. Afterwards, turn again to position '1' .
4 F U E L F I L L E R C A P
There can be refueled at he diesel engine & burner by opening / loosening the
filler cap of the fuel tank below the machine (see "Visual perception" on page
15 ).
5 T E M P E R AT U R E C O N TAC T
The oil temperature of the engine is read out, an alarm message will appear on
the burner switch led. If this temperature becomes too high, the engine will be
switched off.
DiBO 21
E N
O P E R AT I O N