Configuration; Lifting Instructions; Important - Migatronic OMEGA 220 Manuel D'instruction

Configuration

MIGATRONIC disclaims all responsibility for damaged
cables and other damages related to welding with
undersized welding
measured by welding specifications e.g. in relation to
permissible load.
Warning
Connection to generators can damage the welding
machine.
When connected to a welding machine, generators
can produce large voltage pulses, which can damage
the welding machine. Use only frequency and voltage
stable generators of the asynchronous type.
Defects on the welding machine arising due to
connection of a generator are not included in the
guarantee.

Lifting instructions

Lifting hooks can be used at the OMEGA 400 S and
the OMEGA sack barrow for lifting with a crane
(figures 1 and 3). The OMEGA trolley with four wheels
cannot be lifted with a crane but only manually using
the handle (figure 2).
The machine must not be lifted with a mounted gas
cylinder!

Important!

In order to avoid damage to plugs
and cables, good electric contact is
required when connecting the work
return cable and welding torch to the
machine.
Connection of shielding gas
The shielding gas hose is fitted to the back panel of
the power source (3) and is connected to a gas supply
with a pressure reduction to max. 6 bar. One gas
cylinder can be mounted on the bottle carrier on the
back of a trolley if any.
Connection of torch for MIG/MAG welding
The welding hose assembly is pushed into the central
connector coupling (4) and the nut (5) is tightened by
hand. The return lead is connected to the negative
pole (6).
torch and welding
Torch adjustment (Dialog torch)
The current size can be adjusted both from the
machine and the welding torch if a welding hose with
cables dialog torch is in use. This function cannot be
disconnected. The torch adjustment is passive without
Dialog torch.
Inching
The function is used for wire inching e.g. after change
of wire. Wire inching starts by pressing the green key
pad and simultaneously triggering the torch trigger.
Wire inching continues even though the green key pad
has been released. It does not stop until the torch
trigger has been released again. OMEGA 400 has an
additional wire inching key inside the wire chamber.
19