Software - Migatronic OMEGA 220 Manuel D'instruction

It is necessary to read software inside the new control
unit by means of a SD card, if the control unit has
been exchanged.
The software is placed on a SD card which must
contain the folders and one or more of the files as
shown below. The folder names must be saved in BIG
letters and with the original names.

SOFTWARE

Software reading
 Insert the SD-card in the slide in the right side of
the machine.
 Turn on the machine.
 The display flashes shortly with three lines.
 Wait until the set current is displayed.
 Turn off the machine and remove the SD card.
 The machine is now ready for use.
Software reading OMEGA 400 S
 Turn off the machine
 Remove the right side plate
 Insert the SD-card in card holder at the PCB
 Turn on the machine
 The display flashes shortly with three lines
 Wait until the set current is displayed
 Turn off the machine and remove the SD card
 Mount the right side plate

All machine user settings are deleted when
new software has been inserted. Therefore,
always remove the SD-card from the machine
after the software update. Thereby, continuous
software update is avoid each time the machine
is turned on.
22