EKOM DK50 2V/50/M Manuel De L'utilisateur page 39

INSTALLATION

Connect the pin for equipotential bonding
6 mm (1) to the electrical circuit using the
defined method
engineering regulations

The socket for equipotential bonding (2) is an
accessory and is not provided in the basic
package
 Mount the connector of the grounding conductor on the door and screw on the cabinet.
Power supply connection
Supply voltage
230V/50 (60) Hz
400V/50 (60) Hz
13.1. Connecting a compressor not installed in a cabinet
 Insert the mains plug into a rated mains socket.
 The compressor is ready for operation.
13.2. Connecting a compressor installed in a cabinet
 Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors (Fig. 12).
 Connect the cabinet electrically to the compressor by inserting the provided power cord with
connector into an outlet. (Fig. 13)
 Disconnect the cabinet electrically from the compressor by pulling the connector from the outlet
while the latch is released.
 Connect the display at the front door of the cabinet and then secure the cord to the display in
the clamps (1) (Fig. 18, Fig. 21).
Fig. 12: Opening in the rear wall of the cabinet
03/2022
under valid electrical
Electric wire type
3Gx1.5x4000
5Gx1.5x4000
39
Fig. 11 :Equipotential bonding
NP-DK50 2V 50, 2x2V 110-AD-1_03-2022