GETINGE Arjohuntleigh Bari-Breeze Notice D'utilisation page 19

During this time the display will show " " to
C" or "d
indicate the system is in the centralising phase.
The time selected for the turn is the amount of time (in
Turn Times
minutes) the mattress will remain in each position
during the selected turn sequence.
Four settings are available to select the amount of turn
Turn Angle
given to the patient. These are selected using the turn
angle button , where 4/4 is equal to approximately 40
degrees.
These controls adjust the firmness of the mattress. Using
Comfort Control Level
the button reduces the pressure setting, and the
button increases it.
The current comfort level (1-9) will be displayed in the
LED display.
Pump functions (including power/standby switch) can
Lock Out
can be locked out to prevent unintentional change of
modality / cell pressures. To activate, press the lock
button for approximately 2-3 seconds until the blue LED
illuminates. To deactivate, press and hold the lock out
button until the LED turns off.
Alarms
In the event of a power fail situation, the pump will alert
Power Fail
the carer by flashing the amber LED and
Power Fail
sounding the buzzer. Once the power is restored to the
pump the alarm will cease and the pump will return to its
previous operating settings.
In the event of hose disconnection, an ' and ' will
Low Pressure L' P'
alternate on the LED display (representing "Low
Pressure") while the buzzer sounds to alert the carer to
the alarm condition. Once the hose is reconnected, the
alarm will cease and the pump resume its previous
therapy settings.
10