Skyranger Nynja Manuel De Montage page 267

b) Check that the upper mounting brackets are long side downwards, Figure 229.
c) The jury strut components are of differing lengths. Determine the correct tubes
for each position.
d) The horizontal bracing strut should be cut to length, drilled and fitted to the lift
struts, Figure 230.
Figure 229; jury strut upper bracket, fuselage to left of picture.
e) Ensure that the horizontal brace is not being bent into a curve by misalignment
of the lift struts.
If necessary the stainless-steel lift strut end fittings may be tweaked
slightly.
f) Then cut, drill and fit the front and rear jury struts.
Ensure that they fit properly, without pushing or pulling the lift struts out
of line. The ends of the tubes will need to be filed to clear their
mounting bolts as required.
The tubes should be on the inboard side of the brackets.
Figure 230; jury strut to lift strut attachment, fuselage to left of picture.
Nynja Manuel de montage Version 5
267