Table des Matières
Publicité
f) Both breather fittings should have individual lengths of tubing attached, routing
directly upwards to curve over and into the tops of the rear cabin uprights tu6,
Figure 180.
This ensures a reasonable static pressure, and that the pipes discharge
overboard.
Use a short length of bent aluminium tube at the top ends of the plastic
tubes, otherwise the plastic tubes are likely to kink where they are bent
over to fit into the top of the rear cabin uprights.
g) Secure the pipes at the top of the tanks using pieces of fuel tube with cable-
ties passed through them between the pipes and the tank handles, as seen in
Figure 175.
Nynja Manuel de montage Version 5
12..Système d'alimentation essence
Figure 180; fuel tank breather.
178
Publicité
Table des Matières
