Skyranger Nynja Manuel De Montage page 175

d) In a similar manner fit the breather tube to the top of the port tank.
e) When all the holes have been drilled and the pipes fitted into place, carefully
rinse any swarf out of the tanks and pipes with water, and allow to dry with the
tops removed.
f) It is worth trial fitting the tanks in place to determine the lengths of fuel pipe
required, then remove them and fit as much of the piping as possible before
actually fitting the tanks to the aircraft. Otherwise it is quite difficult to fit some
of the pipes in situ.
12.2.1 Fuel tank load spreader bars
Ensure that these were fitted earlier, in the section on the forward fuselage.
Nynja Manuel de montage Version 5
12..Système d'alimentation essence
Figure 175; top of right fuel tank.
Figure 176; fuel tank spreader bar.
175