Operating Procedures - Textron Jacobsen Tri-King Triplex Manuel De L'opérateur Et De Sécurité

5.3

OPERATING PROCEDURES _________________________________________________

A Rollover Protection Structure (ROPS) for this tractor is available as an optional accessory. Evaluate the terrain
and working conditions to determine if a ROPS is required. Seat belts must be worn whenever a ROPS is installed
on the tractor. Always keep seat belt snugly adjusted. DO NOT use seat belts on a tractor without a ROPS.
If a ROPS is installed and the tractor is overturning, hold onto the steering wheel. Do not attempt to jump out or
leave the seat.
CAUTION:
T o help prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and
!
ear protection.
1. Under no circumstances should the engine be started
without the operator seated on the tractor.
2. Do not operate tractor or attachments with loose,
damaged or missing components. Whenever possible
mow when grass is dry.
3. First mow in a test area to become thoroughly familiar
with the operation of the tractor and control levers.
Note:To prevent damage to the reel and bedknife never
operate the reels when they are not cutting grass.
Excessive friction and heat will develop between the
bedknife and reel and damage the cutting edge.
4. Study the area to determine the best and safest
operating procedure. Consider the height of the grass,
type of terrain, and condition of the surface. Each
condition will require
precautions. Only use accessories and attachments
approved by Textron Turf Care And Specialty Products.
5. Never direct discharge of material toward bystanders,
nor allow anyone near the machine while in operation.
The owner/operator is responsible for injuries inflicted
to bystanders and/or damage to their property.
CAUTION: Before mowing, pick up all debris
!
such as rocks, toys and wire which can be
thrown by the machine. Enter a new area
cautiously. Always operate at speeds that allow
you to have complete control of the tractor.
6. Use discretion when mowing near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious
injuries to bystanders and/or damage the equipment.
7. Disengage the drive motors and raise the implements
when crossing paths or roadways. Look out for traffic.
!
WARNING
certain adjustments
!
8. Stop and inspect
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
!
Before you clean, adjust, or repair this equipment,
always disengage all drives, lower implements to
the ground, engage parking brake, stop engine and
remove key from ignition switch to prevent injuries
9. Slow down and use extra care on hillsides. Read
Section 5.7. Use caution when operating near drop
offs.
10. Look behind and down before backing up to be sure of
a clear path. Use care when approaching blind
or
corners, shrubs, trees or other objects that may
obscure vision.
11. Never use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
are extremely sharp and can cause serious injuries
OPERATION
the equipment for
!
WARNING
5
damage
GB-11