Setting Remote Control Codes - Yamaha RX-V757 Mode D'emploi

Setting remote control codes

You can control other components by setting the
appropriate manufacturer codes. Codes can be set up for
each input area.
The following table shows the factory preset component
(Library: component category) and the remote control
code for each area.
Remote Control Code Default Settings
Component
Input area category
(Library)
A LD
B CD-R
PHONO TV
V-AUX VCR
TUNER TUNER
MD/CD-R MD
CD CD
DTV/CBL TV
VCR 1 VCR
DVR/VCR2 DVR
DVD DVD
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try to set other YAMAHA remote control code(s).
1
Press an input selector button to select the
source component you want to set up.
A B PHONO MULTI CH IN
V-AUX TUNER MD/CD-R CD
DTV/CBL VCR 1 DVR/VCR2 DVD
Manufacturer
Yamaha
Yamaha
–
–
Yamaha-3
Yamaha-1
Yamaha-1
–
–
Yamaha
Yamaha-1
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
LEARN
Be sure to press and hold LEARN for at least 3
seconds, otherwise the learning process will start.
y
Complete each of the following steps in 30 seconds.
Otherwise, the learning mode will be automatically
canceled. In this case, press LEARN again.
If you want to change a library (component
category), press j / i. You can set a different
type of component.
Library choices: L:DVD, L:DVR, L:LD, L:CD,
L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*,
L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR
*
The amplifier Library (L:AMP) code is preset to "ID1" to
operate this unit. However, you can switch between the
following two codes if necessary.
The initial setting for "Amplifier library" is "ID1".
AMP library
code
(remote Function
control
setting)
ID1 To operate this unit using the
(initial setting) default code.
ID1Z To operate this unit using the
default code.
To operate Zone 2 or Zone 3
features (see page 76).
(RX-V757 only)
To operate this unit using an
ID2
alternative code.
To operate this unit using an
alternative code.
ID2Z To operate Zone 2 or Zone 3
features (see page 76).
(RX-V757 only)
When using multiple YAMAHA receivers/amplifiers, you may be
able to operate the other components simultaneously with the
default code setting. In this case, set one of the alternative codes
to operate this unit separately
REMOTE CONTROL FEATURES
Remote
control ID
(this unit's
setting: see
page 67)
ID1
(initial
setting)
ID2
69