Yamaha RX-V757 Mode D'emploi page 63

■ Low-frequency effect level
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Choices: –20 to 0 dB
E)LFE LEVEL
. SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
[ ]/[ ]:Up/Down
[<]/[>]:Adjust
Speaker SPEAKER
Select to adjust the speaker LFE level.
Headphone HEADPHONE
Select to adjust the headphone LFE level.
Note
Depending on the settings of "LFE LEVEL", some signals may
not be output from the SUBWOOFER OUTPUT jack.
■ Dynamic range
F)DYNAMIC RANGE
Use to select the amount of dynamic range compression to
be applied to your speakers or headphones. This setting is
effective only when the unit is decoding Dolby Digital and
DTS signals.
Choices: MIN (minimum), STD (standard), MAX
(maximum)
F)DYNAMIC RANGE
. SP: MIN STD)MAX
HP: MIN STD)MAX
[ ]/[ ]:Up/Down
[<]/[>]:Select
Speaker SP
Select to adjust the speaker compression.
Headphone HP
Select to adjust the headphone compression.
• Select MIN if you regularly listen at low volume levels.
• Select STD for general use.
• Select MAX to preserve the greatest amount of
dynamic range.
■ Audio settings
E)LFE LEVEL
Use to customize this units overall audio settings.
Muting type MUTING TYPE
Use to adjust how much the mute function reduces the
output volume.
Choices: FULL, –20dB
• Select FULL to completely halt all output of sound.
• Select –20dB to reduce the current volume by 20 dB.
Audio delay AUDIO DELAY
Use to delay the sound output and synchronize it with the
video image. This may be necessary when using certain
LCD monitors or projectors.
Choices: 0 to 160 ms
Tone bypass TONE BYPASS
Use to select whether audio output bypasses tone control
circuitry when TREBLE and BASS are set to 0 dB (see
page 31).
Choices: AUTO, OFF
• Select AUTO if you want signals to bypass tone control
circuitry to provide the purest signal possible.
• Select OFF if you do not want signals to bypass tone
control circuitry.
G)AUDIO SET
G)AUDIO SET
. MUTING TYPE;;FULL
AUDIO DELAY;;0ms
TONE BYPASS;;AUTO
[ ]/[ ]:Up/Down
[<]/[>]:Select
SET MENU
61