Setting Remote Control Codes - Yamaha RX-V459 Mode D'emploi

REMOTE CONTROL FEATURES

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. You can set the remote
control codes for each input source. For a complete list of
available remote control codes, refer to "LIST OF
REMOTE CONTROL CODES" at the end of this manual.
The following table shows the default component
(Library: component category) and the remote control
code for each input source.
Remote Control Code Default Settings
Library
Input
(component
source
category)
CD CD
MD/CD-R CD-R
DVD DVD
TUNER
TUNER
*1
DTV/CBL
–
*2
DVR –
V-AUX –
–
*1
You can control this unit only.
*2
You can only set TV remote control codes in DTV/CBL.
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try setting other YAMAHA remote control codes.
80
Default
Manufacturer
code
YAMAHA 199
YAMAHA 499
YAMAHA 699
YAMAHA Fixed
– –
– –
– –
– –
1
While hold down CODE SET, press one of the
input selector button or
component you want to set up.
While holding
down
CODE SET
Note
You need hold down CODE SET throughout this procedure.
2
While holding down CODE SET, press the
numeric buttons (0 to 9) to enter the three-
digit remote control code for the component
to be used.
When the setting succeeds, "PRESET OK" appears;
however, when it does not, "PRESET NG" appears in
the front panel display. Refer to "LIST OF REMOTE
CONTROL CODES" at the end of this manual.
While holding
down
CODE SET
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• You can only assign one remote control code to each input
selector button.
to select the
CD MD/CD-R
DVD DTV/CBL DVR V-AUX
STEREO MUSIC ENTERTAIN MOVIE
1 2 3 4
STANDARD SELECT EXTD SUR. DIRECT ST.
5 6 7 8
SPEAKERS ENHANCER NIGHT STRAIGHT
9 0 10 ENT.