Settings; Appliance Shutdown - Stiebel Eltron SHP-F 220 Premium Utilisation Et Installation

iNSTallaTiON

Settings

12. Settings
Service menu „
To unlock the service menu, you need to connect a service plug
or enter a code.
Accessing the service menu with a service plug
1
1 Slot X1
f Plug the service plug into slot X1 on the back of the program- f
ming unit.
Accessing the service menu by entering a code
Press the "Menu" button for longer than
3 s. The software version number of the
controller PCB appears.
Display
301
To display the software version number
of the programming unit PCB, press the
"Plus" button.
Display
-103
To go to code entry, press the "Minus"
button.
To go from the software version num-
ber of the controller PCB directly to code
entry, press the "Minus" button.
To go to the code digit check, press the
"Rapid heat-up" button. The currently
active digit flashes.
Set the first digit using the "Plus" and
"Minus" buttons.
To set the next digit, press the "Rapid
heat-up" button.
To confirm the code after entering all
digits, press the "Rapid heat-up" but-
ton.
28 | SHP-F 220-300 Premium
Version number
3.1.00
Version number
1.3.00
 „ Service menu
…  Integral sensor offset
…  Set the cylinder volume
…  Compressor lockout due to evaporator fault
…  Clear high pressure lockout
…  Clear low pressure lockout
…  Temperature of evaporator fins
…  Number of times hot gas temperature sensor was triggered
…  Number of defrost faults
…  Number of low pressure triggers
…  Number of high pressure triggers
…  Hot gas temperature switching value
…  Fan lead time
…  Integral sensor replacement
… 
Set value limit
The parameters in this menu are reserved for qualified contrac-
tors.

13. Appliance shutdown

Material losses
!
If you disconnect the appliance from the power supply, it
is no longer protected against frost or corrosion.
f Only disconnect the appliance from the power sup- f
ply for longer periods if you are also draining the
DHW cylinder.
The appliance can only be switched off by interrupting the power
supply.
f Pull the mains plug from the socket or disconnect the appli- f
ance from the mains at the MCB/fuse in the fuse box.
14. Troubleshooting
WARNING Electrocution
Prior to all work on the appliance, isolate it from the
power supply.
Material losses
!
If you disconnect the appliance from the power supply, it
is no longer protected against frost or corrosion.
f Only disconnect the appliance from the power sup- f
ply for longer periods if you are also draining the
DHW cylinder.
f For work inside the appliance, remove the appliance cover f
(see chapter "Cleaning and maintenance / Removing the ap-
pliance cover").
f If necessary, remove the upper section of the casing jacket f
(see chapter "Maintenance and cleaning / Removing the cas-
ing ring").
Note
Refit the casing ring after completing the work. See chap-
ter "Maintenance and cleaning / Fitting the casing ring").
www.stiebel-eltron.com