Eurocave Wine Bar 8.0 Mode D'emploi page 25

Possible incidents
The air vacuum plunger does not fully
lower
Water is appearing under the appliance The condensation water drawers are
The compressor is not working
The compressor does not stop
The display indicates
The display indicates
If your appliance appears to be functioning abnormally, contact your Eurocave Professional dealer.
Causes
full
The temperature has been 37°F / 3 °C
below the temperature limit.
or
The temperature has been above the
77°F / 25°C temperature limit.
or
Corrective action
After checking that the plunger is not in
"serving" position, lightly press the top
of the lever.
Open the 2 doors. Gently pull the 2
drawers towards you and empty them.
Replace them by pushing horizontally
under the appliance in the slots
provided.
If the compressor is not working even
though the temperature requested is
lower, by more than 2°C, than the
ambient temperature, then ensure that
the wall socket is supplied with power
by plugging in any other electrical
appliance.
Also check that the appliance is not
in "standby" mode (refer to chapter:
Setting temperatures-placing
appliance on standby)
If the compressor never stops, put your
hand on the condenser (black metal
grill at the back of the appliance). If
the condenser is cold: contact your
retailer. If the condenser is warm, set
your appliance on the warmest possible
setting. If the compressor still does not
stop, contact your retailer.
Indicator alarms, the appliance is still
functioning normally.
Check that the doors are shut and that
the ambient temperature is within the
permitted range. If the problem still
persists after a few hours, contact your
Eurocave Professional dealer.
the
-25-