Eurocave Wine Bar 8.0 Mode D'emploi page 23

Protecting your open bottles from oxidation:
1
Open the compartment door.
2
If the air vacuum system head is in the protection
position, place the neck of the open bottle directly under
one of the air vacuum plungers and raise the bottle whilst
centring it vertically in the bottle holder (ensure that there
are no objects that could obstruct the bottle neck).
3
If the air vacuum system head is in serving position, first
place it in protection mode. To do so, turn the plunger to
the left to release it and move it down to the low position.
Removing a bottle
1
Open the compartment door
2
Remove the bottle without handling the air vacuum system
head.
3
If need be, place the air vacuum system head in "serving"
mode. We do not recommend that you activate vacuum
sealing each time you handle the bottle but rather at the
The lighting of your appliance:
Your Wine Bar 8.0 has multicolour LED lighting. It is supplied with a remote
control for setting the lighting functions.
The sensor of the lighting controller is located on the front between the two
doors. When using the remote control, always ensure that you are standing in
front of the appliance.
M
M
M
OPERATION:
1 2 3 4
1 2 3 4
3
1 2 4
Press once to activate the lighting mode.
M M
Light
Light
Light
1 2 1 3 2 4 3 4
ON / OFF
M
M
Light Light
Automatic colour variation or pause.
1 2 3 4
3
1 2 4
2 3 4
ght
Setting colours. Pressing one of these keys will cause the automatic
M
Light
colour variation function to stop.
1 2 3 4
M
Setting brightness, valid only for fixed lighting.
Light
1 2 3 4
Setting the speed of colour variation, or sensitivity for the music
function.
Light
Music mode: the colours vary according to the sound intensity.
Save function
M
1 2 3 4
The save function can only be used in fixed colour mode.
Light
Set the desired colour by pressing
Press
The colour is stored on the key selected.
Whenever you press this key the stored colour will appear.
M M
then or
1 1 2 2 3 3 4 4
M
1 2 3 4
Light Light
Light
Then place the neck of the open bottle
under the air vacuum plunger and
raise the bottle until it is in the vertical
position
4
The air vacuum system then
activates itself for a few seconds
(the appliance is then operating
independently),
5
Close the compartment door
end of service or when you have finished using the appliance
(vacuum sealing a bottle repeatedly can affect the duration
of preservation of wine).
4
Close the door
N.B: The pump will activate itself again (which is normal) for
approximately 10 seconds.
M M
3 3
1 1 2 2 4 4
Light Light
or .
1
2
3
M
1 2 3 4
Light
-23-