Height-Adjustable Armrests; Options - Hemiplegic Armrest; Options - Anti-Tip Tubes; Options - Lap Belt - Breezy RubiX2 Notice D'utilisation

HEIGHT-ADJUSTABLE ARMRESTS

To adjust the height, pull the lever (1) and
push the armrest to the desired height.
Afterwards make sure that the lever (1)
locks back into position. Removing the
armrest is carried out in the same way.
To remove the sideguard completely, push
the lever (2). When fitting the sideguard, the lever (2) must also be
pulled.
Always make sure that the sideguard locks into position
correctly in the receiver. (Fig. 34)
Options – Hemiplegic armrest
HEMIPLEGIC ARMREST
The hemiplegic armrest can be
adjusted both in length and angle.
You can adjust the length by
pushing the armrest after having
loosened the 2 rotary screws (1).
To adjust the angle, open the
release lever (2) and rotate the
armrest to the desired position,
then tighten it again (Fig. 35).
Options – Anti-Tip Tubes
ANTI-TIP TUBES
Anti-tip tubes provide additional
safety for inexperienced users when
they are still learning how to operate
their wheelchair. They prevent a
wheelchair from tipping over
backwards. The anti tip tube should
be inserted into the frame tube until
the first of the two spring buttons
enters the first hole in the frame tube,
(Fig.36).
WARNING!
Incorrect setup of the anti-tips will increase the risk of a rearwards
tip. You must swing the anti-tips upwards when going up or down
large obstacles, (such as a kerb), to prevent them from touching the
ground, then rotate them back down to the normal position.
NOTE: Do not insert both buttons of the anti tip tube into the frame
tube as this could damage the anti Tipp and cause a loss of
effectiveness. By pushing on the Second exposed release button,
the safety wheels can be set upwards or removed. There must
always be a gap of between 3 cm and 5 cm between the tube and
the ground. You must swing the safety wheels upwards when going
up and down large obstacles (such as a kerb) to prevent them from
touching the ground. Then rotate the safety wheels back down to
the normal position (Fig. 36).
WARNING!
Incorrect set up of the anti tips will increase the risk of a rearwards
tip.
Fig.34
1
2
Fig.35
1
2
Fig.36
Options – Lap belt
WARNING!
Before using your wheelchair ensure the seat belt is worn and
correctly adjusted before use.
The lap belt is fitted to the wheelchair as shown in the illustrations.
The seat belt comprises 2 halves. They are fitted using the existing
seat stay retaining bolt fitted through the eyelet on the belt. The belt
is routed under the rear of the side panel. (Fig. 37)
Adjust the belt position so buckles are in the centre of the seat. (Fig.
38)
Fig.37
Adjust lap belt to suit the user's needs as follows:
To increase the belt To reduce the belt
length
Type B
Feed free belt Feed free belt back
through slide adjust- through male buckle
ers and male buckle and slide adjusters.
to provide more belt
length.
Fig.38
lenght
Type B
Type B
Ensure belt is not
looped at male
buckle.
RubiX 17
2