SOLIS 5514 Mode D'emploi page 59

DE SCALI NG T H E G LA S S J UG
n
• After prolonged use or through the exposure to hard water, limestone deposits
might form in the jug. A white layer of limestone forms on the inside of the jug.
This can reduce operating performance and impair the taste of the water / tea.
Caution: If the limestone layer is very thick, it might cause the appliance to
overheat and damage it beyond repair!
• Solis recommends regularly (depending on water hardness, however at least
once a month) descaling your jug with a mixture of SOLIPOL
This also applies if you use filtered water. Please use only SOLIPOL
703.01) for descaling the appliance. Damages caused by the use of unsuitable
descaling agent are not covered by warranty.
•
Remove the tea strainer.
• Pour 400 ml of cold water into the glass jug and switch the appliance on. Bring
the water to the boil with the water cooker function 100°/BOIL.
Take the water jug off the base, carefully open the lid (Caution, hot steam!)
and pour 800 ml SOLIPOL forte into the water jug so that the descaling solu-
®
tion reaches the MAX marking. Please ensure that the glass jug is placed on a
non-sensitive resp. shielded worktop.
•
Let the descaling solution sit for approx. 30 minutes. Do not boil!
• Slowly pour the descaling solution out through the spout to descale that area as
well. Remove possibly remaining limestone deposits on the spout with a towel
soaked in a solution of SOLIPOL forte and water.
®
• After you have poured the descaling solution away, you have to fill the jug three
times with fresh, cold tap water up to the MAX marking, bring it to the boil
with the function 100°/BOIL and pour the water away each time to remove all
residues of the descaling solution. Let the appliance cool down between two
boiling processes!
116
forte and water.
®
forte (art.-no.
®
s STORAGE
• When not needed, the Tea Kettle should be disconnected from the power, be
allowed to cool down completely and then dried.
• Wind the power cord around the cord wrap in the bottom of the appliance base.
• Place the dry lids and the dry tea strainer on resp. in the dry jug.
• Store the cool, clean and dry appliance in an upright position, best in the original
packaging. Do not place any objects on the appliance.
117