Warm-Keeping Function; Switching The Appliance Off; Good To Know - SOLIS 5514 Mode D'emploi

s WARM-KEEPING FUNCTION
The warm-keeping function prevents the tea resp. the hot water in the
glass jug from cooling down in the next 30 minutes. Depending on the set
temperature, the warm-keeping function varies between 65°C and 90°C.
In the following cases, the warm-keeping function is activated automa-
tically:
• After the steeping time of a certain tea program has elapsed. The
warm-keeping function can be identifi ed by the slow fl ashing of the blue light
of the button surround. 30 seconds after the steeping time has elapsed, another
signal sounds to remind you to remove the tea strainer from the jug. This pre-
vents the tea from getting too strong. At the end of the warm-keeping phase,
after 30 minutes, a sixfold signal sounds, the appliance switches off and the
button surround of the START/STOP button changes to blue and the tea program
button lights up constantly in blue as well.
• At the end of the classic water cooker function, if you have selected the
100°/BOIL program. Here, too, the blue light of the button surround only fl ashes
slowly if the warm-keeping function is activated. At the end of the warm-keep-
ing phase, after 30 minutes, a sixfold signal sounds, the appliance switches off
and the button surround of the START/STOP button changes to blue. The 100°/
BOIL button, too, lights up constantly in blue.
• Important: If you disconnect the glass jug from the appliance base during the
warm-keeping phase (START/STOP button surround lights up in blue) and place
the jug back on the base before the 30 minutes of the warm-keeping phase have
elapsed, you have to reactivate the warm-keeping function by briefl y pressing the
START/STOP button. The button surround of the START/STOP button changes
back to red, the warm-keeping phase is continued until the 30 minutes have
elapsed.
• To fully cancel the warm-keeping function, press the START/STOP button for at
least 2 seconds, the button surround changes to blue. The chosen program, too,
lights up constantly in blue.
112
s SWITCHING THE APPLIANCE OFF
• Every program and every function can be interrupted at all times. To do so,
you can press the START/STOP button for 2 seconds to switch the appliance to
operating mode.
• To switch the appliance off, press the START/STOP button for 2 seconds to switch
the appliance to operating mode (when the program hasn't fi nished yet) and
then pull the power plug to disconnect the appliance from the power.
•
The power plug should be pulled after every use, so that the appliance is com-
pletely disconnected from the power and switched off.
OV ER HE AT PR OTE C TI ON OV E R HE AT P R OTE C T I ON
Should the appliance overheat, e.g. if there is no or too little water in the jug Should the appliance overheat, e.g. if there is no or too little water in the jug
or if it has already evaporated, the appliance automatically switches off. In this or if it has already evaporated, the appliance automatically switches off. In this
case, pull the plug and let the appliance cool down for approx. 30 minutes case, pull the plug and let the appliance cool down for approx. 30 minutes
before using it again.The buttons can only be used again once the appliance before using it again.The buttons can only be used again once the appliance
has cooled down suffi ciently. Never try to cool the appliance down by fi lling has cooled down suffi ciently. Never try to cool the appliance down by fi lling
it with cold water! Always let the appliance cool down between two heating it with cold water! Always let the appliance cool down between two heating
phases. phases.
s GOOD TO KNOW
1. Never exceed the MAX marking when fi lling the jug as this might cause the
water to splash out of the jug during boiling and cause scalding resp. electric
shock!
2. Filled to the MAX marking, the jug holds 1,2 litres of water.
3. Never fi ll the jug with too little water. The MIN marking (500 ml) has to be
reached every time, otherwise the overheat protection is triggered and the
appliance switches off.
4. Always check if the lid is correctly closed before connecting the power plug to
the socket.
5. Dry the outside of the jug including the jug bottom as well as the appliance base
before plugging in the plug.
6. During a program, you can deactivate it at any time by pressing the START/STOP
button for 2 seconds.
113