SOLIS 5514 Mode D'emploi page 54

by 100°/BOIL. After that, the appliance automatically switches to the warm-keep-
ing phase.
• Press the START/STOP button for 2 seconds to switch the appliance off. The
button surrounds of the START/STOP button and the 100°/BOIL button light up
constantly in blue.
• Carefully pour the water out of the spout, with the lid closed.
• Let the appliance cool down and refill it with cold tap water. To do that, just
removing the lid insert is enough.
• Repeat the boiling process another time, pour that water away as well.
• Now your appliance is ready for use.
106
s STARTING UP
Please note:
Safety advices for using the appliance
WARNING: Hazard of injury and burns!
• The surfaces marked with the
process and stay hot for some time after. This concerns the glass jug, the lid with
the grey lid insert, the tea strainer and of course the water / the tea in the jug.
Be especially careful when opening the lid insert to mount the tea strainer, use
cooking gloves or a kitchen towel.
Thus, act with caution:
• Before connecting the appliance mind to check the proper sitting of the tea jug and
•
Do not overfill the glass jug! Please note the MAX marking, otherwise the boiling
that the water container is filled sufficiently with water (observe the filling capacity
of at least 0.5 l or max. 1.2 l).
water might splash out. • To avoid overflow the maximum filling capacity of 1.2 l must not be exceeded.
Switch off and unplug the appliance immediately in case of spilling water!
• The central base with electrical connection must always be clean and dry. No water
may be spilled on electrical connections!
• Keep in mind that the appliance base, the power cord and the power plug as
• Let the appliance cool down before filling water into the water container. Only use
cold tap water for this appliance.
• Do not heat other liquids like e. g. milk or similar.
well as the outsides and the bottom of the glass jug must never become wet.
• Only operate the appliance with jug lid in place. Do not remove the lid during
operation.
• Do not use the appliance as a storing place and do not cover it during use.
• Observe the following when setting up the appliance:
o Place it beyond children's reach.
S T EP 1: F IL LI NG THE G LAS S JUG W I TH C OL D T AP W ATE R
n o Place the appliance on a heat-resistant, stable and even surface.
o Do not operate the appliance in the vicinity of sources of heat (oven, gas flame
etc.) or in explosive environments, where inflammable liquids or gases are located.
o Leave a ventilation distance of at least 20 cm to all sides to avoid damage by heat
• Remove both lids or just the lid insert from the jug and fill the jug with cold tap
or steam and to grant an unobstructed work area.
o Make sure there are no objects or furniture sensitive to heat or moisture above the
appliance. Make sure steam can draw off easily!
water (not ice water), at least up to the MIN marking. Do not exceed the MAX
• Never operate the appliance without water.
• Do not handle the appliances with hands wet.
marking.
• For a safe switch-off pull the mains plug after each use.
•
The tea strainer is not yet placed in the jug.
• Close the jug with the lid. The lid ring has to line up with the edge of the jug all
around, the arrow on the lid insert must first be in the "OPEN" position, then in
the "CLOSE" position.
• If necessary, dry the outside of the glass jug as well as the jug bottom. Place the
jug on the dry appliance base.
S T EP 2: C ONNE C TI NG TH E APP LI AN C E TO TH E POW E R
n
• Connect the power plug to a suitable power outlet, the power cord must be
completely unwound.
• The appliance switches to operating mode, a signal sounds and all button
surrounds light up briefly in blue. After that, only the button surrounds of the
START/STOP button and the GREEN TEA button light up constantly in blue.
Standby mode / Power saving mode:
If you do not press any button within a timeframe of 5 minutes, the appliance
switches to power saving mode, all button surrounds go out. In this case, you
simply have to lift the glass jug, disconnect it from the base and then place it
back on the base or press a random button to return the appliance to oper-
ating mode.
• The surfaces of appliance, glass jug, lid, lid insert, tea infuser as
symbol become very hot during the boiling
well as the liquids are getting hot during use and firstly stay hot
after switch-off.
• Mind the hot steam coming out when removing the lid from the
glass jug or the lid insert for the infuser respectively. Use e. g. a
tea towel to protect your hands from scalding!
• Do not overfill the jug (observe the max. filling quantity)!
Spilling and overflow during operation might cause hazard of
scalding!
• The tea jug is made of glass. In case of breakage mind the sharp
and pointed edges!
• Do not use a damaged tea jug!
19
107