DriSteem Vapormist Humidi-tech CRUV Manuel page 3

Va p o r m i s t / H u m i d i - t e c h / C R U V, s t a n d a r d w a t e r, s e r v i c e k i t p a r t s
This service kit contains the replacement parts called out in the
parts drawing to keep your DRI‑STEEM humidifier operating
at peak performance. This Service Kit Manual provides
important safety and service instructions; it is intended to
supplement — not replace — the humidifier's Installation,
Operation, and Maintenance Manual. Please see Read all
warnings and instructions on page 1.
While performing service and maintenance procedures,
replace existing parts with the new parts provided in the
service kit.
Enclosure Screw Cap
(Vapormist/Humidi-tech)
OM-778-3
Probe Tool
3/8" drive
1
OM-7395X
Torque probe assembly
to 10 ft-lbs (13.6 N-m).
mc_051508_1320
mc_052808_1400
Fill Valve
3
Sediment screen (3)
inside of Tee
TANKASM-VM2-4X
DRI-STEEM Vapormist/Humidi-tech/CRUV, Standard Water, Service Kit Manual • Page 3
Note: Components may by oriented
differently than shown in drawing.
Apply clear silicone (2) to both sides of gasket.
See Fill Valve inset.
Vapormist/Humidi-tech only
6
4
7
5
8
OM-768X