Installing The Module And Pulley - Aprimatic WING NK Instructions

Installation
7.

INSTALLING THE MODULE AND PULLEY

!
Warning
WORKSITE SAFETY
Prevent the access of unauthorised persons to the work area.
Use safety ladders, work in pairs and pay special attention
when handling the parts so that they do not fall or knock
against any components or persons.
1 Insert the Module in its housing and connect it to the NK
Beam as illustrated in Figs. 2a-2b.
2 Insert the screws in the 7 holes on the Module profi le, without
tightening them, as illustrated in Fig. 2c.
3 Insert the Pulley in its housing on the NK Beam as
illustrated in Figs. 3a-3b.
WARNING: during installation, make sure that the pulley
is adjusted to permit subsequent tensioning of the belt
(see Fig. 4).
4 Insert the screws in the 4 holes on the Pulley profi le, without
tightening them, as illustrated in Fig. 3c.
5 Slide the Module and Pulley along the Beam Profi le and
put them in the correct position for the type of installation
(Figs. 5a-5b).
6 Secure the Module and Pulley by tightening down all the
screws on the beam profi le.
7 Make the connections, referring to the WING NK Control
System Manual enclosed.
INSERT
the Module
fi g.2a
INSERT
the pulley
fi g.3a
fi g.4
securing
screws
loosen the 2 securing screws to permit ADJUSTMENT;
1
loosen the adjustment screw to set the maximum X distance
2
possible;
when finished, tighten the 2 securing screws again.
3
SECURE
the Module
fi g.2b
SECURE
the pulley
fi g.3b
10
- -
To create the beam and install the wings, we enclose
NK beam with sliding wing system Instruction
Manual.
For the electrical installation and the correct use of
the automation, we enclose the WING NK CONTROL
SYSTEM Instruction Manual.
POSITION of the Pulley for
installation
X
insert the 7 screws in the
corresponding holes
fi g.2c
insert the 4 screws in the
corresponding holes
fi g.3c
adjustment
screw