Technical Specifications; Module Components; Obligatory Accessories - Aprimatic WING NK Instructions

4.

TECHNICAL SPECIFICATIONS

See Table 1.
5.

MODULE COMPONENTS

The Module provides the basic automation components pre-
assembled on a single support.
The unit is fitted to the beam and disassembled very easily. If
required, removing/replacing the individual components fitted to
the Module is equally simple.
The Module consists of an aluminium PROFILE, 110 cm long, to
which the automation control electronics and drive components
are fitted:
• Power supply unit
• Control unit
• Emergency batteries
• Gear motor
The Module pack also includes:
• The idle pulley with the elements for assembly to the
beam
• The Instruction pack for the mechanical and electrical
installation and the Adhesive labels
Check that all the components are present and not damaged
as indicated in Table 2.
6.

OBLIGATORY ACCESSORIES

The MODULE also requires the following accessories, to be
purchased separately.
• Drive belt
• Hardware KIT*
*
Use of the hardware kit is illustrated in the NK beam with
sliding wing system Instruction Manual enclosed.
fi g.1
Tab.2
MODULE Components
1 Module support profile (110 cm)
2 Control units
3 Power supply unit
4 Emergency batteries
5 Gear motor
Instructions and Adhesive label pack
NK Module Instructions
NK BEAM and WING SYSTEM Instructions
WING NK CONTROL SYSTEM use
and electrical installation instructions
6
4
7
WING NK MODULE Technical specifications
Mains power supply voltage
Power supply voltage for accessories 24 VAC
Operating temperature
Maximum absorbed power
Qty. 1
Qty. 1
Qty. 1
Qty. 1
Qty. 1
Qty. 1
Qty. 1
Qty. 1
3
2
7a
8
9
- -
Technical specifi cations / Components
230 V ~ (+/-10%) 50Hz
-10˚/+60˚C
300 W
For further details, see the WING NK Control System
Instructions.
Fig. 1 and Tab. 2 illustrate the WING NK MODULE with
the idle PULLEY and the non-assembled components
included in the pack.
Components not pre-assembled to the Module
6 Round head Module screws 5x8
7 Idle pulley on securing profile (25 cm)
8 Round head Pulley screws 5x8 U8112
External Aprimatic adhesive labels
RHS/LHS arrow adhesive label
1
5
Tab.1
Qty. 7
Qty. 1
Qty. 4
Qty. 4
Qty. 1