Deleting A Remote Control; Accessories; Ca41 Module; Kb Or 128 Kbits Memory Expansion Module - Aprimatic T11 Instructions Pour L'installation

the BZ1 buzzer come on (continuous beeping) to inform you that the self-teaching
stage is running.
4. Now press any key on the transmitter.
5. The DL6 LED and the BZ1 buzzer go off briefly briefly and then come back
on, confirming the self-teaching of the remote control within the memory of the
receiver built in the device.
button 2
Aprimatic
button 1
5.4 SELF-TEACHING PROCEDURE OF OTHER REMOTE CONTROLS
When the self-teaching of the fi rst remote control is completed, while the signal is still
ON, you can add other remote controls by repeating steps 3 and 4.
Afterwards, you can start the remote control saving procedure again by pressing, at the
same time, all the buttons on a TX which has already been saved: the buzzer will sound
and you can now add extra remote controls by repeating steps 3 and 4.
INFORMATION:
• The procedure for self-teaching of the fi rst remote control, as described above, is
only possible if the RX memory is completely empty.
• To quit the saving procedure, simply press the delete button.
• In any case, the system remains in self-teaching mode (continuous buzzer)
for a maximum of about 25 seconds before the receiver automatically returns to
normal mode (buzzer OFF).
• During the self-teaching procedure, the device outputs are disabled.

5.5 DELETING A REMOTE CONTROL

1. With the device powered up, hold down the delete button: the DL6 LED and the
BZ1 buzzer come on (continuous buzzer).
2. Press any button on the remote control you want to delete.
3. The DL6 LED and the BZ1 buzzer will go off to indicate that deletion of the
remote control is complete.
• To delete more than one remote control, repeat stage 2 above, holding down
the button.
• This procedure is useful for deleting remote controls which have been saved
by mistake. However, you can subsequently save the remote control deleted in the
receiver again, following the procedure described above.
ENGLISH
button 1 button 2
Aprimatic
button 3 button 4
Power supply
Button
Remote control
activation
Buzzer

6. ACCESSORIES

6.1 CA41 MODULE

By fi tting this module to the device, the user will have an additional receiving channel: in
this way, with the SAME DEVICE AND THE Aprimatic two-key STANDARD REMOTE
CONTROL, he will be able to control two different appliances.

6.2 16 KB OR 128 KBITS MEMORY EXPANSION MODULE

By fi tting this module to the device, the latter will be enabled to controlup to 1500
operations.

6.3 PROGRAMMING TOOLS

The Aprimatic devices and remote controls can also be programmed using:
• APRITOOL programmer for the access control management
• APRICOT-MANAGER software for managing access controls
• Connecting unit for programming APRIBASE 1 transmitters.

6.4 SAFETY CARD

Accessory card for activating the anti-crush function for both electromechanical motors.
Functioning is factory-set and shall not be adjusted.
When the anti-crush function is activated, the led corresponding to the involved
motor lights up on the card.

6.5 CODED KEYPAD

It is possible to install a coded keypad by connecting the CT3 decoding card to
the K3 connector.

6.6 BADGE READER

It is possible to fi t a badge reader by connecting the LB4 decoding card to the
K3 connector.
8