Huntleigh MD200 Mode D'emploi page 7

Product Name:
Model No.:
Physical Characteristics:
Audio Output:
RS232:
Analogue:
Digital:
CAL Function:
Auto Shut-Off:
Battery Charging:
Battery Life:
Fuse:
Power Supply:
Probe Transmiter
Frequencies:
Effective Area of Active
Transmitter Element:
TECHNICAL SPECIFICATION
MD200 Desktop Doppler
MD200
Weight : 1448 gms
Height : 240mm
Speaker:
Headphones :
8 pin sub miniature DIN socket, provides analogue and digital waveform
outputs (max Applied voltage +5Vdc).
Zero crosser, 3.5V full scale per channel (forward and reverse).
Conversion factor automatically adjusted to give full scale outputs at
±0.1% (±10%) of probe frequency (e.g. ±8kHz for VP8HS)
RS232C, Data formatted to interface with Printa II or Recorder software
running on compatible computer. Conversion factors automatically set as
per analogue outputs.
Automatic sequence of CAL levels set to ±0.05% (±10%) and ±0.1%
(±10%) of probe frequency (e.g. ±4kHz & ±8kHz for VP8HS) with
zerobaseline at start and end of sequence.
After 5 minutes of no signal
Recharge time, approximately 2 hours
Typically, 400 x 1 minute examinations from full charge (depending on
use)
T250mAH, 250V
European version only - 230V ~ 50Hz 10VA
USA version only - 120V ~ 60Hz 10VA
Saudi Arabia Version Only - 220V ~ 50/60Hz 10VA
~ : Alternating Current
Refer to rear panel for details of power supply option.
OP2HS : 2.0MHz ± 1%
OP3HS : 3.0MHz ± 1%
VP4HS : 4.0MHz ± 1%
VP5HS : 5.0MHz ± 1%
VP8HS : 8.0MHz ± 1%
VP10HS : 10.0MHz ± 1%
EZ8 : 8.0MHz ± 1%
IOP8: 8.0MHz ± 1%
OP2HS, OP3HS :
VP4HS, VP5HS :
VP8HS, VP10HS :
EZ8 :
IOP8: 12.5 mm² (± 20%)
7
Width : 227mm Depth : 79mm
500mW rms typical
25 mW rms (32Ω headphones)
(max applied voltage +9Vdc)
233 mm² (± 15%)
22 mm² (± 15%)
8 mm² (± 20%)
16 mm² (± 20%)