Warranty & Service; End Of Life Disposal; Electromagnetic Compatibility - Huntleigh MD200 Mode D'emploi

WARRANTY & SERVICE
Huntleigh Healthcare's standard terms and
conditions apply to all sales. A copy is available
on request.
These contain full details of warranty terms and
do not limit the statutory rights of the consumer.
Service Returns
If for any reason your Dopplex Unit is being
returned, please:
1. Clean the product, as described in
the cleaning section.
2. Pack it in suitable packing.
3. Attach the decontamination
certificate (or other written
statement declaring that the
product has been cleaned) to the
outside of the package.
4. Mark the package "Service
Department - MD200"
UK
For further details refer to the NHS document
HSG(93) 26.
For service, maintenance and any questions
regarding this, or any other Huntleigh
Healthcare Dopplex product, please contact:
Huntleigh Healthcare Ltd
Diagnostic Products Division
35 Portmanmoor Road
Cardiff
CF24 5HN UK
Tel : +44 (0)29 20485885
Fax: +44 (0)29 20492520
Or your local distributor.
Manufactured in the UK by Huntleigh
Healthcare Ltd. As part of the ongoing
development programme the company reserves
the right to modify specifications and materials
of the MD200 without notice.
Dopplex, Huntleigh and 'H' logo are registered
trademarks of Huntleigh Technology Ltd 2004.
©Huntleigh Healthcare Ltd. 2004
END OF LIFE DISPOSAL
This symbol signifies that this product,
including its accessories and consumables is
subject to the WEEE (Waste Electrical and
Electronic Equipment) regulations and should
be disposed of responsibly in accordance with
local procedures.

Electromagnetic Compatibility

Make sure the environment in which the
Doppler is installed is not subject to strong
sources of electromagnetic interference
(e.g. radio transmitters, mobile phones).
This equipment generates and uses radio
frequency energy. If not installed and used
properly, in strict accordance with the
manufacturer's instructions, it may cause or
be subject to interference. Type-tested in a
fully configured system, complies with IEC
60601- 1-2, the standard intended to
provide reasonable protection against such
interference.
Whether the equipment causes interference
may be determined by turning the
equipment off and on. If it does cause or is
affected by interference, one or more of the
following measures may correct the
interference:
• Reorienting the equipment
• Relocating the equipment with respect to
the source of interference
• Moving the equipment away from the
device with which it is interfering
• Plugging the equipment into a different
outlet so that the devices are on different
branch circuits
6